FLEX-2
PSI-68SuppressionFlame Extinguishment Experiment - 2
Objectives
- Investigate the role of liquid-phase mixing on the burning characteristics of bi-component fuel droplets.
- Examine the steady and unsteady liquid and gas-phase phenomena in pure fuel combustion.
- Study flame extinction mechanisms and their boundaries.
- Analyze the soot formation process, including soot volume fraction soot-shell dynamics.
- Determine the influence of droplet interactions on the flammability limits and extinction behavior of droplet arrays.
- Validate theoretical models of droplet combustion through comprehensive experimental data collection in microgravity environments.
The chamber was filled with the appropriate atmosphere, which was varied in pressure between 0.5 atm to 3.0 atm and O2 concentration between 0.1 to 0.4 mole fraction with the diluent gas making up the balance. A settling time of approximately 2 minutes elapsed prior to initiating the test in order to ensure that the temperature and pressure of the chamber gases have stabilized. This settling time was followed by the dispensing of a predetermined amount of fuel (based on the target droplet size) onto the support fiber for those tests in which the droplet is not freely deployed. When sufficient fuel has been dispensed the dispensing needles were retracted and a dwell period of at least 10 seconds was allowed for the droplet internal fluid motion induced by deployment to subside. This was then followed by initiating power to the ignitor for a selectable amount of time ranging from 1 second to 5 seconds after which the ignitor was retracted from the field of view. If the flow field is to be generated by translating the droplet then droplet motion would commence at the same time that the ignitor is retracted. A near real-time download of the color camera video was employed in order to verify successful droplet deployment, ignition, and overall progress of the experiment. Pressure and temperature data of the chamber environment was also recorded in near real time.
Conditions
| Parameter | Tested value or range | Unit |
|---|---|---|
| Oxygen | 10 to 40 | % by volume |
| Pressure | 7.348 to 44.088 | psi |
| Pressure | 50.663 to 303.975 | kPa |
| Airflow | – | cm/s |
| Gravity | Microgravity | |
| Diluents | helium, carbon dioxide, xenon, nitrogen | |
| Fuel phase | Liquid | |
| Fuels | n-heptane, methanol, ethanol, 1-propanol, n-octane, n-decane, n-butanol, gasoline, methyl butanoate, methyl decanoate, Jet-A, nonane, propanol, acetone, decane, hexanol, dodecane | |
| Sample geometry | droplet | |
| Sample size | 0.67 mm to 1 mm | as stated |
| Hardware | MDCA | |
| Platform | ISS | |
| Years | 2016-2019 |
A dash means the sources do not state the value.
Variables varied
- Fuel type
- Ambient gas composition
- Ambient Pressure
- Droplet initial diameter
- Droplet translation velocity (and acceleration)
- Droplet spacing and initial size in a binary linear array
Variables held fixed
- Ambient Temperature
Sensors
- color camera
- high speed photography
- pressure sensor
- temperature sensor
Findings (14)
Key findings
Results indicate that ambient gas transport properties play an important role in determining flammability and combustion behaviors including burning rates and radiant heat output histories of the droplets.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
Droplets would burn with significantly higher mole fractions of xenon than helium or carbon dioxide.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
It is found that light diffraction at the droplet edge can contribute significantly to errors in droplet size measurements.
Source: Interpretation of Backlit Droplet Images from ISS Droplet Combustion Experiments, p. 1 (DOI)
Other error sources include background light variations and partial coherence effects.
Source: Interpretation of Backlit Droplet Images from ISS Droplet Combustion Experiments, p. 1 (DOI)
Results show that it is possible to automate data analysis for consecutive droplet burning images even in the presence of a significant amount of noise from soot formation.
Source: AUTOMATED DATA ANALYSIS FOR CONSECUTIVE IMAGES FROM DROPLET COMBUSTION EXPERIMENTS, p. 1 (DOI)
An adaptive grayscale intensity threshold provides the ability to extract droplet diameters for the wide range of noise encountered.
Source: AUTOMATED DATA ANALYSIS FOR CONSECUTIVE IMAGES FROM DROPLET COMBUSTION EXPERIMENTS, p. 1 (DOI)
In instances where soot blocks portions of the droplet, the algorithm manages to provide accurate measurements if a circle fit is used instead of an ellipse fit, as an ellipse can be too accommodating to the disturbance.
Source: AUTOMATED DATA ANALYSIS FOR CONSECUTIVE IMAGES FROM DROPLET COMBUSTION EXPERIMENTS, p. 1 (DOI)
Ignition
Comparison with previous experimental data shows that ignitability and combustion characteristics of droplets are influenced by the fuel type and also the gravitational level.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
Flame spread
Burning rates were about 40% to 70% higher in normal gravity than in reduced gravity.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
Methanol droplets also had burning rates that were typically larger than 1-propanol burning rates by about 20% in reduced gravity.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
In normal gravity, however, burning rate differences between the two fuels were significantly smaller.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
After considering measurement uncertainties, burning rates decreased appreciably as the initial droplet diameter increased for combustion in air but not for combustion in the oxygen/helium environments.
Source: Combustion of Submillimeter Heptane/Methanol and Heptane/Ethanol Droplets in Reduced Gravity, p. 1 (DOI)
It was also found that addition of either methanol or ethanol did not influence burning rates appreciably and that burning rates were larger for the oxygen/helium environments than for air if initial droplet diameter dependences were accounted for.
Source: Combustion of Submillimeter Heptane/Methanol and Heptane/Ethanol Droplets in Reduced Gravity, p. 1 (DOI)
Extinction
In reduced gravity, droplets would burn steadily with a xenon mole fraction of 0.50 but would not burn steadily if helium or carbon dioxide mole fractions were 0.50.
Source: Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
Fire safety relevance
Insights gained from these studies can lead to more efficient and cleaner combustion technologies, future combustor designs with minimal carbon footprint, maximum fuel efficiency, and less pollutant emissions, as well as validation of jet engine models and development of fuel surrogates.
Tests (8)
| Test | Sample | Fuel | Sample geometry | O2 (%) | Pressure (psi) | Airflow (cm/s) | Diluent | Outcome | Spread rate (mm/s) | Notes |
|---|---|---|---|---|---|---|---|---|---|---|
| PSI-68-T1 | row 1 | IsoOctane (pure) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T2 | row 2 | n-Octane (pure) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T3 | row 3 | Heptane (pure) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T4 | row 4 | Decane (pure) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T5 | row 5 | Ethanol (pure) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T6 | row 6 | Propanol (95%) Glycerol (5%) (mixture) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T7 | row 7 | Heptane (50%) IsoOctane (50%) (mixture) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
| PSI-68-T8 | row 8 | Propanol (80%) Glycerol (20%) (mixture) | – | – | – | – | O2/N2 or O2/He | Not stated | – | Initial Droplet Diameter: 1.5 - 5 mm. Oxygen Mole Fraction: 0.17; 0.21; 0.25; 0.3. Ambient Pressure: 0.5; 1.0; 1.5; 2.0; or 3.0 atm. Ambient Temperature: 25 C. Flow Velocity: 0.1 - 5 cm/s. |
Sources (6)
- Flame Extinguishment Experiment - 2, p. 1 (DOI)
- PSI-68 Experimental table Flex2, p. 1
- Combustion of Methanol Droplets in Air-Diluent Environments with Reduced and Normal Gravity, p. 1 (DOI)
- Combustion of Submillimeter Heptane/Methanol and Heptane/Ethanol Droplets in Reduced Gravity, p. 1 (DOI)
- Interpretation of Backlit Droplet Images from ISS Droplet Combustion Experiments, p. 1 (DOI)
- AUTOMATED DATA ANALYSIS FOR CONSECUTIVE IMAGES FROM DROPLET COMBUSTION EXPERIMENTS, p. 1 (DOI)